Use and Care Manual

For technical support and assistance, call 844-894-6659
31
UNDERSTANDING OPERATING MODES
Your spa controls are equipped with three operating modes to help you regulate energy consumption and reduce operating costs.
How often the spa is used and the ambient temperature will help you determine which mode is best for you.
Ready Mode
The water is always heater to the programmed temperature setting.
“Ready” is displayed on the topside controls.
When the spa is in Ready Mode, it’s always ready to use when you’re ready to use it because the programmed temperature setting is
automatically maintained. The current water temperature will be displayed on the topside controls. Pump 1 will automatically circulate
on low speed for a few minutes every half hour to check the water temperature keeping it consistent throughout the spa and to
sanitize the water with Ozone.
Rest Mode
The water only heats during ltration cycles and may be too cool for immediate use
“Rest” is displayed on the topside controls.
DO NOT PUT THE SPA IN REST MODE WHEN THE AMBIENT TEMPERATURE IS 40º F OR LOWER!
Rest Mode reduces energy consumption by heating the water only during ltration cycles only. In Ready Mode, the water
automatically begins heating when the temperature falls a couple of degrees. In Rest Mode, the water temperature is allowed to
uctuate. When the spa is in Rest Mode, setting the ltration cycle to end right before use can be an eective way to reduce energy
consumption. The topside controls will not display the current water temperature until pump 1 is turned on to circulate the water for
approximately 1 minute.
Ready-In-Rest Mode
In Rest Mode, the water heats for 1 hour when the “Pump 1” button is pressed
Unless the “Pump 1” button is pressed, the water only heats during ltration cycles.
In Ready-In-Rest Mode the spa will operate in Rest Mode, heating only during ltration cycles, unless the “Pump” 1 button is pressed.
When the “Pump 1” button is pressed, the system assumes it is in use and the water begins heating as it circulates for one hour. If the
programmed temperature setting isn’t reached within the hour, the pump automatically shuts o.
To change operating modes, press the “Temp button. While the display is ashing, repeatedly press the “Light” button until “MODE”
appears on the topside display. Press the “Temp” button to toggle between operating modes. When the desired mode is displayed,
press the “Light” button to save your selection.