Use and Care Manual

For technical support and assistance, call 844-894-6659

Heater Related Messages

Reduced Heater Flow

There may not be enough water ow away from the heater. DO NOT ENTER THE WATER! Water temperature readings in the heater

chamber are too high. Heater will restart in approximately 1 minute.

Reduced Heater Flow

Not enough ow to carry water away from the heating element and the heater has been disabled. DO NOT ENTER THE WATER!

Power off GFCI, make sure slice valves locked in open position, that water level is adequate and remove debris from lter, lter basket

and suction drain cover. Press any button to resume operation. If problem is not resolved, call 844-894-6659 for assistance.

Heater may be Dry

There is not enough water in the heater. Add water to the spa if the water level is too low, check to be sure slice valves are locked in the

open position, that pumps are primed and jets are open. When problem is resolved, press any button to resume operation.

Heater is too Hot

One of the temperature sensors has detected high temperature in the heater chamber and the spa is shut down. DO NOT ENTER

THE WATER! Power o GFCI, make sure slice valves locked in open position, that water level is adequate and remove debris from

lter, lter basket and suction drain cover. Press any button to resume operation. If problem is not resolved, call 844-894-6659 for

assistance.