Use and Care Manual

For technical support and assistance, call 844-894-6659
45
The Slice Valves (“T” Stems) allow service without draining the all of the water from the spa. Slice valves or “T” stems are installed in the
plumbing lines near the pump(s) Pushing the “T” stem down creates a seal between the “T” stems. When service is complete, the “T”
stems are raised and locked in the up position. Slice valves must be locked in the “up” position before power is applied to the spa. If
the spa is turned on and the slice valves are closed it can damage the spa immediately. Each time you change the water in the spa, you
should check to be sure the locks on the slice valves are in good condition; locks should be replaced if they will not hold the “T”stem in
the “up” position. Do not use the spa until the locks have been replaced.
The Plumbing Unions connect the plumbing lines to the spa components. Unions can become loose in transit and when seasons
change. During the initial installation and each time you drain your spa, you should hand tighten all plumbing unions. The main cause of
leaks inside the spa cabinet is plumbing unions that need to be tightened. Do not use tools or overtighten plumbing unions
The Filter Assembly consists of the lter, the lter basket and the weir. The lter basket catches large debris, the lter catches ne
particulates and oil. You should check the lter assembly on a regular basis making sure the basket is free of debris and the lter is in
good condition. If the lter assembly is obstructed, ow will be restricted which can damage the spa. Using the spa without the lter
assembly in place is a drowning hazard and may damage the spa. If any part of the lter assembly is damaged, do not use the spa until
it has been replaced. Please call technical service at 844-894-6659 for replacement parts. Before removing the lter assembly to ll the
spa or change the lter, manually power the GFCI “OFF”. Turn the weir counter clockwise until it stops. Lift the weir, raise and remove
the basket. Lift the lter from lter housing. Replace the lter, basket and weir. Turn the weir assembly clockwise until it stops and is
locked in place. The manufacturer recommends that you replace the lter every three months. To prevent air in the plumbing lines, you
should soak new lters in water for 30 minutes before installing.
The Suction Drain Covers are on the sides in the foot well of the spa. They are caps that cover the suction drains to help prevent risk of
drowning and debris from being sucked into the plumbing lines. If the suction drain covers are obstructed, ow is restricted which can
damage your spa. Keep hair, clothing and children away from the suction drains when using the spa. It is important to check them on a
regular basis making sure they are good condition Do not use the spa if they need to be replaced. Replacement parts can be obtained
Getting to Know Your Spa