- HAI (Home Automation Inc.) Home Security System User Manual

Page 49
SETUP EXPANSION
To configure each Expansion Module that is installed on your system, from the Installer Setup menu, press the 7 (EXP) key.
Expansion Modules include Hardwire Zone Expanders, ALC Interface Modules, and Serial Interface Modules using either the
Omni-Link or Pro-Link Protocol.
MODULE 1 TYPE
The Module Type defines the function of each expansion module on the controller. Module 1 is the module with the ADDR
jumper set to 1. Set the module type from the list below. Press ' # ' to change the module type, then use the arrow keys to select
the proper module type, then press ' # ' to enter.
MODULE 1 TYPE 1
NOT USED #=CHNG
↓
Select from the following for the module with jumper set to 1:
MODULE TYPES NUMBER DESCRIPTION
NOT USED 0 No module is installed
HARDWIRE EXPNDR 1 Model 10A06 Hardwire Expander installed
ALC 2 ALC Interface Module is installed
OMNI-LINK 3 Model 10A17 Serial Interface using the Omni-Link protocol
PRO-LINK 4 Model 10A17 Serial Interface using the Pro-Link protocol
Notes:
1. Only 2 Model 10A06 Hardwire Expander Modules can be installed. When a Wireless Receiver is configured, only 1
Hardwire Expander Module can be installed.
2. Only 1 Serial Interface Module can be installed and configured (Omni-Link or Pro-Link). To configure the protocol for the
built-in serial port, set the "Serial 1 Function" to the desired protocol.
MODULE 2 TYPE - MODULE 4 TYPE
Module 2 is the module with the jumper set to 2, and so on. Set each module type from the list above.
SERIAL 1 RATE
"Serial 1 Rate" selects the baud rate used for the built-in serial interface (J1 Serial) on the Omni II controller. Select the baud rate
for the built-in serial interface from the list. Use the arrow keys to select the baud rate then press the ' # ' key.
BAUD RATE NUMBER
75 baud 1
150 baud 2
300 baud 3
600 baud 4
1200 baud 5
2400 baud 6
4800 baud 7
9600 baud 8 (default)