Instructions / Assembly

Assembly — Installing the Light Kit

AAA

Attaching the switch housing

to the mounting ring

□ Remove one of the three switch housing mounting

screws (JJ) from the mounting ring (YY) and loosen

the other two screws (JJ). (Do not remove.)

□ While holding the switch housing (J) under the fan

motor assembly (G), snap together the wire connec-

tion plugs (ZZ).

□ Place the key holes in the switch housing (J) over the

two screws (JJ) previously loosened from the

mounting ring (YY). Turn the switch housing (J) until

the switch housing (J) locks in place at the narrow

section of the key holes.

□ Securely tighten the two mounting plate screws (JJ)

previously loosened and the one (JJ) previously

removed.

CAUTION: Before starting installation, disconnect the

power by turning off the circuit breaker or removing the fuse

at the fuse box. Turning power off using the fan switch is not

sufﬁcient to prevent electric shock.

NOTE: If you do not wish to install the light kit, skip steps

11 through 13 and proceed to step 14.

Attaching the light kit to

the switch housing

□ Remove the three light kit mounting screws (KK) from the

light kit (K) and keep these screws.

□ While holding the light kit (K) under your fan motor

assembly (G), locate two single white and blue wires in

the switch housing labeled "FOR LIGHT". Make the

polarized plug connections (AAA):

- White to white

- Blue to black

□ Carefully push all wires back into the switch housing.

Install the light kit (K) onto the switch housing with the

three light kit mounting screws (KK) provided. Be sure to

tighten all screws.