Installation Guide

Operation

3 4

Adjusting the heater

Press the Heater button to set the thermostat. The replace

contains three infrared quartz heating elements.

The thermostat setting range is 62°F - 82°F or 17°C - 27°C

or always ON.

The thermostat is adjustable by 2°F or 1°C increments.

The up and down buttons“ ”on the remote will

increase / decrease temperature setting.

NOTE:

To change between °F and °C press and hold the

HEATER button on the control panel for 3 seconds.

Push the Power button to supply power to all

functions of the replace and put the insert in a

standby mode.

Push the Power button again to turn off all functions.

1 2

Powering the replace

NOTE:

Holding the Power button on the control panel for

3 seconds will disable the heater function.

NOTE:

All previous settings are held in memory, so the

next time you power up the replace, the unit will turn on

with the same settings.

Adjusting the ame

There are 6 brightness levels that can be selected:

Settings F6 - F4 decrease in Amber brightness

Settings F3 - F1 decrease in Spectrare brightness

Pressing the Timer button will cycle through the timer

settings; 30 minutes, 1 Hour, 2H, 3H, 4H, 5H, 6H, 7H,

8H, 9H and off.

Setting the timer

NOTE:

The control panel can be accessed at the upper-right corner of the insert.

When a function is changed from the control panel or remote control there will be a

corresponding indicator (see Figure 1) on the upper-right of the projection screen.

The indicator shows the function changed and the level selected by the control

panel or remote control. When the function is turned off, the corresponding indicator

will ash several times and then fade off.

Fig . 1