Installation Guide

To secure the Foot (M) to the Bottom Base Panel (A),

insert the Screws (JJ) through the pre-drilled holes.

Tighten the Screws (JJ) with the Phillips screwdriver.

Place the Divider (N) on a at surface.

Attach the 3 Hole Plastic Connector Block (FF) using the

Bolts (DD) and the Phillips screwdriver.

Align the Bottom Base Panel (A) with previously

assembled Panels (I,E,F,J).

Secure together using the Screws (II) and the Phillips

screwdriver.

Attaching the foot

Preparing the Divider

Attaching the base

Assembly (continued)