Full Product Manual

14
Operating Instructions (continued)
Increase/Decrease Button
NOTE: This option is only available if using the remote control.
□ Press the INCREASE/DECREASE button to adjust the heater’s thermostat setting.
□ Press the INCREASE/DECREASE button again to scroll up through the pre-set temperature settings: The thermostat setting
range is 65°F (18°C) to 90ºF (32°C), HI (High).
□ Set the temperature to “HI” to have the heater run continually.
Timer Function
□ Press the TIMER icon to set the countdown for the unit’s main power.
□ If the unit is powered OFF, you can press the TIMER icon to power ON the unit. The emberbed will glow at the lowest
brightness setting unless a different setting was saved in the memory.
□ Press the TIMER icon again to scroll through the timer settings, which are: 30, 1H, 2H, 3H, 4H, 5H, 6H, 7H, 8H, 9H, OF. (30
means 30 minutes, OF means OFF)
□ When the timer reaches zero, it will turn OFF the main power and will maintain all the settings in memory.
HEATER OVERRIDE
The power to the heater can be disengaged to prevent the heater from being accidentally or unintentionally powered on. This feature is
primarily added to help prevent children from powering on the heater when it is not desired.
□ To engage the heater override function, press and hold the TEMPERATURE icon for 10 seconds. The symbol E3 will display. The heater
function is now locked. If the TEMPERATURE icon is pressed again E3 will appear then fade. The Flame and Timer functions will
operate normally. Only the heater and blower are disengaged.
□ To unlock the heater function, press and hold the TEMPERATURE icon for 10 seconds. The symbol E3 will display. The heater function
is now engaged. Press the TEMPERATURE icon again to adjust the heat to your desired temperature.
MEMORY FUNCTION
This unit has a memory function that allows you to turn off the MAIN POWER and retains all the other function settings (excluding the
TIMER function).
□ When the unit’s main power is OFF, press the POWER icon once on the insert control panel or on the remote control to power the unit
ON and “wake up” the individual function at the last setting. Press the icon again to adjust it and press the main POWER icon on the
insert or on the remote control to turn the unit OFF and save the new setting into memory.
□ When the unit is powered ON, the LED readout will show the saved temperature setting. If a temperature setting was not saved, it
will show the ame brightness setting saved in memory. If neither one has a setting saved to memory, then only the emberbed will
glow (as a power light indicator).
□ To reset the memory, hold down the main POWER icon for 10 seconds at any time. The LED readout will blink with two zeros three
times and the unit will be shut down.
□ Another way to reset the memory is to unplug the unit from the wall.