Installation Guide

Assembly — Hanging the Fan (continued)
10
6
Preparing the receiver and
remote control
CAUTION: Do not use with a wall light dimmer switch.
WARNING: To avoid possible electrical shock, be sure
electricity is turned off at the main fuse box before wiring.
O
O
P
If you feel you do not have enough electrical wiring
knowledge or experience, have your fan installed by a
licensed electrician.
This remote control unit is equipped with 16 code
combinations to prevent possible interference from or to
other remote units. The frequency switches on your
receiver (O) and remote control (P) have been preset at the
factory. Please recheck to make sure the switches on the
remote control (P) and the receiver (O) are set to the same
position. Any combination of settings will operate the fan
as long as the switches in the remote control (P) and
receiver (O) are set to the same position.
□ After checking the switches, insert the receiver (O)
into the mounting bracket (A) with the flat side of the
receiver (O) facing the ceiling.
H
A