Installation Guide

Attaching the light kit mounting

plate to the mounting ring

□ Remove one of the three light kit mounting plate

screws (MM) from the mounting ring (AAA) and

loosen the other two screws. (Do not remove.)

□ Place the key holes in the light kit mounting plate (L)

over the two screws (MM) previously loosened from

the mounting ring (AAA). Turn the light kit mounting

plate (L) until the light kit mounting plate (L) locks in

place at the narrow section of the key holes.

□ Securely tighten the two light kit mounting plate

screws (MM) previously loosened and the one (MM)

previously removed.

Attaching the LED light kit

and glass shade

Assembly — Installing the Light Kit

CAUTION: Before starting installation, disconnect the

power by turning off the circuit breaker or removing the fuse

at the fuse box. Turning power off using the fan switch is not

sufﬁcient to prevent electric shock.

□ Remove one of the three light kit mounting screws

(NN) from the light kit mounting plate (L) and loosen

the other two screws (NN ). (Do not remove.)

□ While holding the 28W LED light kit (M) under the fan

motor assembly (H), make the 2-pin wire

connections:

- Red to white

- Black to black

□ Place the key holes in the 28W LED light kit (M) over

the two mounting screws (NN) previously loosened

from the light kit mounting plate (L). Turn the 28W

LED light kit (M) until the 28W LED light kit (M) locks

in place at the narrow section of the key holes.

Secure by tightening the two light kit mounting

screws (NN) previously loosened and the one (NN)

previously removed.

□ Place the glass shade (N) over the 28W LED light kit

(M) stem and secure with the plastic nut (PP) (rubber

side on the top) and decorative nut (QQ) provided. Do

not overtighten.

AAA