Instructions / Assembly

21
A-
B-
C-
S e t U p
Carefully remove umbrella mainframe from box and set gently on soft surface. Unfold
canopy and gather from largest side first, slip over top of canopy mainframe so
that the smallest side is left on top. Insert each rib into canopy pocket located on
the inside of canopy. For 6.5x10’ rectangle models, line up ends of canopy with rib
ends. Attach screws onto end of canopy and rib ends using a phillips screwdiver and
tighten to secure.
Attach finial to top of canopy/mainframe. Insert bottom pole into canopy/mainframe
pole. Line up button with hole and snap into place.
O p e n i n g &   T i l t i n g U m b r e l l a
Turn the umbrella upright and crank handle clockwise to open umbrella to its fully open
position. To tilt, continue to turn the crank to desired position.
C l o s i n g U m b r e l l a
Turn crank handle in counter clockwise direction to bring umbrella back to a horizontal
position. Continue to turn crank handle in counter-clockwise direction to close
umbrella.
Thank you for your purchase of Home Decorators Collection Auto Tilt Market
Umbrella. Please remove all contents from the package, inspect and review
checklist.
SAFETY PRECAUTIONS:
Close the umbrella in windy conditions or when a storm approaches.
Never allow the umbrella to flap in the wind; this could damage the canopy.
Do not leave open umbrella unattended. If damage occurs, this is not covered
by the warranty.
When adjusting the umbrella, make sure that no person(s) or item(s) are close to
the umbrella. This is important to prevent injury or material damage.
CARE AND MAINTENANCE:
When not in use, close and cover umbrella with a protective cover.
Allow a wet canopy to dry opened up.
If necessary, clean the fabric with lukewarm water, mild detergent, and a sponge.
Wipe sliding marks on the aluminum poles with a damp cloth.
Winter Storage:
Store in a dry place.
Any visible defects must be repaired by a professional.
After the Winter:
Areas subject to turning and sliding can be treated with a non-staining lubricant
spray (silicone-based).
Check the condition and function of the umbrella. Any defects must be repaired by
a professional.
C H E C K L I S T :
A - (1) Finial
B - (1) Canopy/Mainframe
C - (1) Bottom Pole