Installation Guide

Table Of Contents

HOMEDEPOT.COM/HOMEDECORATORS

Please contact 1-800-986-3460 for further assistance.

Assembly - Standard Ceiling Mount

Routing the wires

Assembling the fan

Preparing for mounting

□ Remove the canopy cover (HH) from the canopy (C) by turn-

ing the bottom cover counter-clockwise until it unlocks.

□ Loosen the two canopy screws (GG) located in the bottom

of the mounting bracket (A), and turn the canopy counter-

clockwise to remove the mounting bracket from the canopy

(C).

□ Route the wires exiting the top of the fan motor

assembly (E) through the decorative motor collar cover

and then the center of canopy bottom cover (HH).

□ Make sure the opening of canopy (C) is on top and

insert the ball/downrod (B) through the canopy (C).

□ Route the wires exiting the top of the fan motor

assembly (E) through the downrod as shown.

□ Loosen, but do not remove, the setscrew (KK) on the collar (JJ)

on top of the fan-motor assembly (E).

□ Install the downrod (B) by inserting it into the motor collar (JJ),

and turning it clockwise until it is tight.

□ Re-tighten the setscrew (KK) on the collar (JJ) on top of the fan

motor assembly (E).

NOTE: This fan is equipped with a safety tab (II). Should

the setscrew (KK) ever become loose while the fan is

running in reverse, the safety tab (II) will engage and stop

the fan from falling.

CAUTION: To ensure wobble-free operation and to avoid

damage to the fan, the downrod (B) and the setscrew

(KK) must be completely tightened