Installation Guide

12
Mounting the fan
Close-to-Ceiling mounting
□ Align the locking slots of the ceiling canopy (C) with the two
screws (JJ) in the mounting bracket (A). Push up to engage
the slots and turn clockwise to lock in place.
□ Firmly tighten the two mounting screws (JJ).
□ Install the two mounting screws (II) (saved from Assembly
Step 1 “Prepairing for mounting”) into the holes in the
canopy (C) and tighten rmly.
□ Install the decorative canopy ring (FF) by aligning the ring’s
slots with the screws in the canopy (C). Rotate the ring
clockwise to lock in place.
9
WARNING: When using the standard ball/downrod mounting, the
tab in the ring at the bottom of the mounting bracket must rest in
the groove of the hanger ball. Failure to properly seat the tab in
the groove could cause damage to the wiring.
E
A
JJ
C
FF
II
WARNING: The locking slots of the celling canopy are provided only
as an aid to mounting. Do not leave the fan assembly unattended
until all four canopy screws are engaged and rmly tightened.
E
C
JJ
FF
A
II
□ Carefully unhook the fan from the mounting bracket (A) and
align the locking slots of the ceiling canopy (C) with the two
screws in the mounting bracket (A). Push up to engage the
slots and turn clockwise to lock the canopy (C) in place. Im-
mediately tighten the two mounting screws (JJ) rmly.
□ Install the remaining two mounting screws (II) into the holes in
the canopy (C) and tighten rmly.
□ Install the decorative canopy ring (FF) by aligning the ring’s
slots with the screws in the canopy (C). Rotate the ring
clockwise to lock it in place.
Assembly - Hanging the Fan (continued)
10
Attaching the fan blades
11
□ Attach a blade (H) to the fan motor housing (E) by rst
inserting the blade (H) into the slot in the side of the fan
motor housing (E).
□ Insert a screw (AA) into the bracket. Repeat for the two
remaining screws.
□ Tighten each screw (AA) securely.
□ Repeat these steps for the remaining blades (H).
H
AA
E