Full Product Manual

HOMEDEPOT.COM/HOMEDECORATORS

Please contact 1-800-986-3460 for further assistance.

Assembly - Attaching the Blades to Blade Bracket

Attaching the fan blades to blade

bracket

□ Attaching the blades to blade bracket by using the blade

attachment screws (AA) and medallion (H) provided, insert

a blade attachment screw (A) through a hole in the blade

bracket (G) and blade (F) and into the medallion (H). Repeat

these steps for the remaining blades (F).

□ Repeat step 1 for attaching the remaining medallions (H).

□ Firmly tighten each screw to secure.

Assembly - Hanging the Fan (continued)

Mounting the fan-motor assembly

(standard mount)

□ Align the locking slots of the canopy (C) with the two screws

(DD) and alignment post (KK) in the mounting bracket (A).

□ Push up the canopy (C) and turn clockwise until the

alignment post (KK) engages to the round hole and the

screws (CC) engage to the key slots.

□ Firmly tighten the two mounting screws (DD).

□ Install the decorative bottom cover (EE) by aligning the cover

slots with screws in the bottom of the canopy (C). Rotate the

bottom cover (EE) clockwise to lock in place.

WARNING: When using the standard ball/downrod mounting,

the tab in the ring at the bottom of the mounting bracket

must rest in the groove of the hanger ball. Failure to properly

seat the tab in the groove could cause damage to the wiring.

Fasten the blade assemblies to the

motor

□ Insert the blade/blade bracket assemblies through the hole in

the side of the center ywheel on the fan-motor assembly (E),

align the two screw holes on blade bracket (G) with two screw

holes on the center ywheel and secure with screws (BB).

□ Repeat this step for the remaining blade assemblies.