Full Product Manual

HOMEDEPOT.COM/HOMEDECORATORS

Please contact 1-800-986-3460 for further assistance.

Assembly - Standard Ceiling Mount

Routing the wiresPreparation for standard mounting

□ Route the wires exiting the top of the fan motor assembly

(E) through the decorative motor collar cover (D) and then

the center of the canopy bottom cover (EE).

□ Make sure the opening of canopy (C) is on top and insert

the ball/downrod (B) through the canopy (C).

□ Route the wires exiting the top of the fan motor assembly

(E) through the downrod as shown.

□ Remove the canopy bottom cover (EE) from the canopy (C) by

turning the bottom cover counterclockwise until it unlocks.

□ Loosen the two canopy screws (DD) located in the bottom of the

mounting bracket (A), and turn the canopy counterclockwise to

remove the mounting bracket (A) from canopy (C).

Assembling the fan

□ Loosen, but do not remove, the setscrew (GG) on the collar

(FF) on top of the fan-motor assembly (E).

□ Install the downrod (B) by inserting it into the motor collar

(FF), and turning it clockwise until it is tight.

□ Re-tighten the setscrew (GG) on the collar (FF) on top of the

fan motor assembly (E).

NOTE: This fan is equipped with a safety tab (HH).

Should the setscrew (GG) ever become loose while

the fan is running in reverse, the safety tab (HH) will

engage and stop the fan from falling.

CAUTION: To ensure wobble-free operation and to avoid

damage to the fan, the downrod (B) and the setscrew

(GG) must be completely tightened.