Instructions / Assembly

15
Operation
NOTE: Wait for the fan to stop before reversing the direction
of the blade rotation.
The reverse switch is located on the surface of the motor assembly.
This switch controls directions: forward (switch left) or reverse
(switch right).
Warm weather - (Counterclockwise Direction) A downward air flow
creates a cooling effect. This allows you to set your air conditioner
on a warmer setting without affecting your comfort.
Cool weather - (Clockwise Direction) An upward air flow moves
warm air off the ceiling. This allows you to set your heating unit on
a cooler setting without affecting your comfort.
HOMEDEPOT.COM/HOMEDECORATORS
Please contact 1-800-986-3460 for further assistance.
Disconnect the power and remove the existing wall plate and
switch. Set all knobs on the dual slide wall-mounted control
in the OFF position. Installation of this control requires that a
three- conductor cable with ground wire be run between the
control wall box and the ceiling fan outlet box. Make wire
connections and secure with wire nuts supplied.
GREEN
BLACK
GROUND
GROUND
TO MOTOR L
AC IN L
L
M
H
0
BLACK
BLACK
Push the control unit into the switch box and secure it with the
two screws at each end of the unit (this procedure is the same
as if you were to put the original wall switch back into the wall).
Now attach the face plate to the wall control.
Speed Control
0: POWER OFF
H: HIGHT SPEED
M: MEDIUM SPEED
L: LOW SPEED
L
M
H
0
WHITE
WALL CONTROL INSTALLATION
REVERSE SWITCH OPERATING INSTRUCTIONS
L
M
H
0
LIVE
NEUTRAL
Connect the Black wire from the ceiling fan to the Black wire
“TO MOTOR L” from the wall-mounted control.
Make sure to use wire nuts on all connections.
Connect the Black (live) wire from the power supply to the Black
wire “AC IN L” from the wall-mounted control.
Connect the White (neutral) wire from the power supply to the
White wire from the fan motor assembly (G).
120V
POWER
SUPPLY
BLACK
WHITE
HH
Before you begin, TURN OFF THE ELECTRICITY at the main
circuit panel or fuse box. If you feel unsure of this procedure,
have a qualified electrician install this unit.
WALL CONTROL OPERATION