Use and Care Guide

HOMEDEPOT.COM/HOMEDECORATORS

Please contact 1-800-986-3460 for further assistance.

Assembly - Standard Ceiling Mount

Routing the wires

Assembling the fan

Preparing for standard mounting

□ Loosen, but do not remove, the setscrews (LL) on the collar on

top of the fan-motor assembly (E).

□ Align the holes at the bottom of the ball/downrod assembly (B)

with the holes in the collar on top of the fan-motor assembly (E).

□ Carefully insert the hanger pin (AA) through the holes in the

collar and ball/downrod assembly (B). Be careful not to jam

the hanger pin (AA) against the wiring inside the ball/downrod

assembly (B).

□ Insert the locking pin (BB) through the hole near the end of the

hanger pin (AA) until it snaps into its locked position.

□ Re-tighten the setscrews (LL) on the collar on top of the fan-

motor assembly (E).

□

Remove the canopy bottom cover (JJ) from the canopy

unlocks.

□

Loosen the two canopy screws (HH) located in the

bottom of the mounting bracket (A), and turn the canopy

counterclockwise to remove the mounting bracket (A)

from the canopy (C).

□ Route the wires exiting the top of the fan motor assembly (E)

through the decorative motor collar cover (D) and then the

center of the canopy bottom cover (JJ).

□ Make sure the opening of the canopy (C) is on top and insert

the ball/downrod (B) through the canopy (C).

□ Route the wires exiting the top of the fan motor assembly (E)

through the downrod as shown.

WARNING: Failure to properly install the locking

pin (BB) could result in the fan becoming loose and

possibly falling.