Instructions / Assembly

Table Of Contents

HOMEDEPOT.COM/HOMEDECORATORS

Please contact 1-800-986-3460 for further assistance.

Assembly - Attaching the Lights

Attaching the light kit tter assembly

□ Remove one screw (NN) from the round hole in the light kit

pan, and loosen, but do not remove the other two screws.

□ Connect the blue wire exiting the bottom of the fan motor

assembly (E) with the black wire from the top of the light kit

tter assembly (I).

□ Connect the white wire exiting the bottom of the fan motor

assembly (E) with the white wire from the top of the light kit

tter assembly (I).

□ Push the light kit tter assembly (I) up to the light kit pan so

that the two loosened screw heads t into the keyhole slots.

Turn the light kit tter assembly (I) clockwise to secure.

□ Re-install the screw (NN) that was removed in step 1.

□ Make sure all the screws are rmly tightened.

CAUTION: To reduce the risk of electric shock, disconnect

the electrical supply circuit to the fan before installing the

light xture.

NOTE: Notice the location of the fan’s slide switch. This is

the switch used to change the fan’s directional rotation.

For more information on the operation of this switch, see

Operating Your Fan and Remote Control on page 14.

Installing the glass shade

□ Place the bowl (J) into the light kit pan (E), by aligning the

three at areas on the top ange of the bowl (J) with the

three raised dimples in the light kit pan.

□ Turn the bowl clockwise until it stops.

CAUTION: Make sure the power is off before attaching or

removing the glass shades.

WARNING: Allow the glass shades to cool completely before

removing.