Installation Guide

Assembly - Close-To-Ceiling Mount

□ Remove three of the six screws and lock washers (MM)

(every other one) securing the motor collar to the top of the

fan-motor assembly (E).

□ Route the wires exiting the top of the fan-motor assembly

(E) through the rubber gasket (DD) aligning the holes in the

rubber gasket (DD) with the three screw holes in the fan-

motor assembly (E).

□ Route the wires exiting the top of the fan-motor assembly

(E) through the canopy ring (HH), and the canopy (C) (make

sure the slot openings for the canopy ring and canopy are

on top). Place the canopy (C) over the collar (II) at the top of

the motor (E).

□ Align the mounting holes in the canopy (C) with the screw

holes in the motor (E) and fasten using the three screws

and lock washers (MM) (removed previously). Tighten the

mounting screws securely.

Routing the wiresPreparing for mounting

□ Remove canopy ring (HH) from the canopy (C) by turning the

ring counterclockwise until it unlocks.

□ Remove the mounting bracket (A) from the canopy (C) by

loosening the two canopy screws (FF) located in the “L

shaped” slots

□ Remove and save the two canopy screws (GG) in the round

holes. This will enable you to remove the mounting bracket

(A).

□ Remove the decorative canopy bottom cover (LL) from the

canopy (C) by pressing the three studs located inside the

bottom of the canopy.