Use and Care Guide

12
Assembly - Attaching the Light Kit
Attaching the light kit tter assembly
2
□ Remove one screw (LL) from the light kit pan (E), and loosen, but
do not remove, the other two screws.
□ Connect the wires from the light kit tter assembly (H) to the
wires from the fan motor assembly (E) by connecting the molded
adaptor plugs together. Carefully tuck all wires and splices into
the switch cup.
□ Push the light kit tter assembly (H) up to the light kit pan (E) so
that the two loosened screw heads t into the keyhole slots. Turn
the light kit tter assembly (H) clockwise to secure.
□ Re-install the screw that was removed in the rst step.
□ Make sure all the screws are rmly tightened.
Installing the light kit pan
1
□ Remove one screw (KK) from the black bracket below the fan
motor assembly (E), and loosen but do not remove the other
two screws.
□ Push the light kit pan (G) up to the fan motor assembly (E) so
that the two loosened screw heads t into the keyhole slots.
Turn the light kit pan (G) clockwise.
□ Re-install the screw (KK) that was removed in the rst step.
□ Make sure all the screws are rmly tightened.
KK
G
E
H
LL
E