Installation Guide

Assembly — Close-to-Ceiling Mounting

Assembling the fan

Preparing the motorPreparing the canopy

□ Remove three of the six collar mounting screws with

lock washers (KK) (every other one) from the collar on

top of the fan motor assembly (G).

□ Route the wires exiting the top of the fan motor

through the canopy ring (B) (make sure the slot

openings are on top), and then proceed to place the

canopy (C) and metal plate (OO) over the collar at the

top of the fan motor assembly (G).

□ Align the mounting holes in the bottom of the canopy

bly (G), and fasten using the three collar mounting

screws with lock washers (KK) previously removed.

□ Tighten the collar mounting screws (KK) securely.

WARNING: Failure to completely tighten the three collar

mounting screws (KK) could result in the fan becoming loose

and possibly falling.

□ Remove the canopy ring (B) from the canopy (C).

□ Remove the mounting bracket (A) from the canopy (C)

by loosening the four canopy mounting screw with

lock washer (BB) on the top of the canopy (C).

□ Remove the two non-slotted canopy mounting screw

with lock washer (BB) and loosen the slotted canopy

mounting screw with lock washer (BB).

□ Remove the canopy bottom cover (D) from the canopy

counterclockwise.