Installation Instructions

10
Installation (continued)
□ Carefully feed the fan’s electrical wiring through the
pivot ball, then reinstall the pivot ball on the downrod (B)
with the flat side facing the ceiling.
□ Reinstall the ground wire with the wire facing up to
ensure proper grounding. Make sure the star washer
is reinstalled in the location shown below.
□ Reinstall the retainer pin (N) in the downrod (B).
□
For Canadian installations, refer to the Canada
Installation Addendum and install the support
cable on the r etainer pin (N) now.
B
B
N
B
N
Lift the pivot ball back to the top of the downrod (B) until the retainer pin
(N) is captured. Tighten the screw to secure.
NOTE: When the pivot ball is oriented correctly on the
downrod (B), it will also cover the ground screw and will be
ush with the top of the downrod (B).