Use and Care Guide

2
Table of Contents
Table of Contents . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2
Safety Information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2
What is cover . . .
What is not covered
.
Warranty . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3
Pre-Installation
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . .
Package Contents
. . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . .
Maintenance
Safety Information
Read all safety warnings and all instructions.
WARNING:
READ AND SAVE THESE INSTRUCTIONS
Use this unit only in the manner intended by the manufacturer. If you have questions, contact the manufacturer.
Before beginning installation, read and understand all instructions and safety information. Thoroughly review all
assembly information and drawings and be sure you understand the assembly requirements.
Before installing, servicing, or cleaning unit, switch power off at service panel and lock the service disconnecting
to prevent power from being switched on accidentally. When the service disconnecting means cannot be
securely fasten a prominent warning device, such as a tag, to the service panel.
Installation and wiring must be in accordance with the National Electrical Code, ANSI/NFPA 70 and all local codes.
If you are unfamiliar with or unable to comply with these requirements, have ceiling fan installed by a licensed
electrician.
When cutting or drilling into wall or ceiling, do not damage electrical wiring and other hidden utilities.
If this unit is to be installed over a tub or shower, it must be marked as appropriate for the application and be
to a GFCI (ground-fault circuit interrupter) protected branch circuit.
Do not bend the blade brackets when cleaning the fan. Do not insert foreign objects in between rotating fan blades.
Mount ceiling fan directly to a structural framing member or to a metal outlet box marked “Acceptable for Fan Support
of 35 lb. or less”. For outlet box mounting, use mounting sc rews provided with the outlet box.
When using an existing outlet box, make sure it is securely attached to the building structure and can support the full
support and would therefore need to be replaced. Do not use a plastic outlet box. Failure to follow this instruction
can result in serious injury or death.
Ensure power is off before beginning installation.
Always turn fan off and allow to come to a complete stop before reversing blade direction.
When installation is complete, make sure all connections are secure to prevent ceiling fan from falling.
All set screws must be checked, and retightened where necessary, before installation.
After making the wire connections, the wires should be spread apart with the grounded conductor and the
equipment-grounding conductor on one side of the outlet box and the ungrounded conductor on the other side
of the outlet box.
The splices after being made should be turned upward and pushed carefully up into the outlet box.
Save these instructions. Refer to them frequently and use them to instruct others who may use this product. If you
loan someone this product, loan them these instructions also.
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
4
Tools Required
Hardware Included . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
5
5
Installation 6-14
Operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
15-16
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
17
Troubleshooting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 18
3
3
3
□
□
□
□
□
□
□
□
□
□
□
□
□
□
□
□
□
□
means
locked,