Use and Care Guide

7
Installation (continued)
2
Preparing Your Ceiling Fan For
Mounting
□ Remove any existing ceiling fan or light where you
intend to install this ceiling fan. Verify the existing
outlet box is marked acceptable for fan support up to
35 lb. and that it is securely fastened to the ceiling
joists.
OUTLET
BOX
For Canadian installations, refer to the Canada
Installation Addendum located in the Canada
Installation Hardware Bag and install the eye
bolt or anchor assembly now..
□ Using the screws provided with the outlet box, attach
the ceiling mounting bracket assembly (A) to the electrical
box, passing the 120V electrical supply wires through
the hole in the center of the mounting bracket assembly (A).
A
ANGLED CEILING
OPEN END
FACING DOWN
ANGLED CEILING
□ Loosen the screw securing the pivot ball portion of the downrod (B).
Slide the pivot ball down and off the downrod (B) and set
aside.
B
□
N
B
HOMEDEPOT.COM/HOMEDECORATORS
Please contact 1-800-986-3460 for further assistance.
Remove the retainer pin (N) from the downrod (B).
NOTE: If you are installing the mounting bracket assembly
(A) for an angled orientation, make sure the open end of the
bracket (A) is installed facing the lower point of the ceiling.