Manualshelf

Measurement Guide

ManualsBrandsHome Decorators Collection ManualsShelves & Shelf Brackets36 in. L x 7.75 in. W Slim Floating White Shelf
12
Use and Care Guide
Floating Wall Shelf
Installation
1
PREPARING FOR INSTALLATION
□ Place the backplate (B) against the
wall in the desired position.
□ While holding the backplate (B)
against the wall, use a level to ensure
that the backplate (B) is level.
□ Use a pencil to mark the backplate
(B) holes on the wall.
□ Ensure that arrow located on
backplate (B) is pointing up.
B
2
INSTALLING THE BACKPLATE
□ Using a power drill and a 3/16 in.
drill bit, drill holes into the wall at the
pencil marks.
□ Insert the drywall anchors (D) into the
holes that do not have studs.
□ Use a Phillips screwdriver and the
screws (C) to secure the backplate
(B) to the wall.
B
C
C
3
INSTALLING THE SHELF
□ Slide the shelf (A) onto the backplate
(B).
□ Align the holes on the bottom of the
shelf (A) with the holes on the bottom
of the tubes on the backplate (B).
□ Use the set screws (E) to secure
the shelf (A) to the backplate (B) by
inserting the set screws (E) through
the bottom of the shelf (A) and into
the bottom of the backplate tubes.
TOOLS REQUIRED
Phillips screwdriver Power drill 3/16 in. drill bit
Level Pencil Stud Finder
(optional)
PACKAGE CONTENTS
A
C
D
E
B
Item #
Model #
See page 2
Template for easy installation:
Afx the template on the wall in the desired location. Using a level, adjust the template until
straight, then attach the template to the wall.
Mark the screw indicator holes and remove the template.
Place the backplate over the holes marks and screw into place.
HOMEDEPOT.COM
Please contact 1-877-527-0313 for further assistance.
M245220 245484 246276 246342 247464 369366 E 6.27.19 V1
E
E
B
A
Note: there are more bracket holes than there are installation screws
24 in 36 in 42 in
Part Description Quantity
A
Shelf 1
B
Backplate 1
C
Screw 6
D
Drywall anchor 4
E
Set screw 2
Quantity
1
1
6
4
2
Quantity
1
1
6
4
2
Make sure that at least one screw hole will be
installed into a wall stud for best results.
IMPORTANT:
Templates will have 7 or
more possible hole locations. Only 6
screws are provided in hardware. Decide
prior to drilling which 6 hole locations will
be used for installation of backplate.
□ Helpful Hint:
Use stud nder to locate wall studs
to hold the maximum weight.
IMPORTANT: If you are drilling into
a stud, do not pre-drill or use anchor.

Summary of content (2 pages)