Use and Care Manual

13
HOMEDEPOT.COM/HOMEDECORATORS
Please contact 1-800-986-3460 for further assistance.
Optional Installation - (continued)
Reinstalling the receiver in the
switch cup
□ Insert the black and white wires (LL) from the light kit (A)
through the center hole of the receiver (NN) one at a time.
□ Insert the receiver (NN) into the switch cup and align the
tabs on the receiver (NN) with the posts inside the switch
cup (E).
□ Attach the receiver (NN) to the switch cup (E) using the
screws (KK saved from step 1). Tighten securely.
□ Attach the white wire from the receiver to the white wire
from the light kit (A).
□ Attach the blue wire from the receiver to the black wire
from the light kit (A).
3
4
Attaching the switch cup and light
kit to the fan
□ Remove one screw (UU) from the switch cup adaptor (H).
Loosen but do not remove the other two screws (UU).
□ Connect the molded adaptor plug of the receiver (NN) in the
switch cup (E) with the molded adaptor of the fan motor
assembly (D).
□ Aligning the “L” shape holes on the switch cup (E) with the
screws on the switch cup adaptor (H). Turn the switch cup
(E) to hold it in position.
□ Install the other screw (UU) that was removed in the rst
step. Tighten all three screws (UU) securely.
□ Refer to your light kit instructions to nish light kit
installation.
CAUTION: To reduce the risk of electric shock, disconnect
the electrical supply circuit to the fan before installing the
switch cup.
IMPORTANT: It is critical to attach the switch cup using the
quick connector. The fan will not operate unless the switch
cup is connected to the fan.
E
UU
MM
MM
H
E
A
LL
NN
KK