Use and Care Manual

15
HOMEDEPOT.COM/HOMEDECORATORS
Please contact 1-800-986-3460 for further assistance.
Operating Your Fan and Remote Control
Learning process
□ Turn the main power source off to begin the learning process.
□ Return the power to the fan.
□ Within 60 seconds of turning the fan’s power ON, press and hold
the “Power” button (VV) on your remote control for 5 seconds.
Once the receiver has detected the set frequency, the down light
of your fan, if applicable, will blink twice. If your fan is currently
on, the fan will stop running. If your fan is currently off, the fan
will move forward at medium speed.
NOTE: After the AC power is on, do not press any other button on
the remote control before pressing the “Power” button (VV). Doing
so will cause the procedure to fail.
Remote control operation
NOTE: The remote control can learn multiple receivers. Make sure
no other receivers are operating during the learning process.
Separate the fan power switches by approximately 2 meters.
XX
WW
VV
3 = High speed
2 = Medium speed
1 = Low speed
(VV) = Power off. Press and release the button to turn the ceiling
fan off.
(WW) = Reverse. Press and release the button to set the fan air
ow direction up or down.
(XX) = Light/Dimmer. Press and release the button to turn the
light on or off. Press and hold the button to dim or brighten the
light to the desired level and then release. (For tungsten bulbs
only and dim light function, turn the switch to “DIM”).