Installation Guide

HOMEDEPOT.COM/HOMEDECORATORS

Please contact 1-800-986-3460 for further assistance.

Operation

3 4

Adjusting the heater

Press the Heater button to set the thermostat. The  replace

contains three infrared quartz heating elements.

The thermostat setting range is 62°F - 82°F or 17°C - 27°C

or always ON.

The thermostat is adjustable by 2°F or 1°C increments.

The up and down buttons“ ”on the remote will

increase / decrase temperature setting.

NOTE:

To change between °F and °C press and hold the

HEATER button on the control panel for 3 seconds.

Push the Power button to supply power to all

functions of the  replace and put the insert in a

standby mode.

Push the Power button again to turn off all functions.

1 2

Powering the  replace

NOTE:

Holding the Power button on the control panel for

10 seconds will disable the heater function.

NOTE:

All previous settings are held in memory, so the

next time you power up the  replace, the unit will turn on

with the same settings.

Adjusting the  ame

There are 6 brightness levels that can be selected:

Settings F6 - F4 decrease in Amber brightness

Settings F3 - F1 decrease in Spectra re brightness

Pressing the Timer button will cycle through the timer

settings; 30 minutes, 1 Hour, 2H, 3H, 4H, 5H, 6H, 7H,

8H, 9H and off.

Setting the timer

NOTE:

The control panel can be accessed at the upper-right corner of the insert.