Installation Guide

1
STEP 3
wall prep
Tape measure
Pencil
Level
Stud Finder
Hammer
Screw Driver
#
2 Flat Head and
#
2 Phillips
#10 x 3" Pan Head Screws
#8 x 1¼" Pan Head Screws
Cordless Drill – to pre-drill cabinets and mount
to wall and to each other
3
/ 16",
3
/ 32" Drill bits
Hacksaw – to cut 48" Closet Rods to size (if needed)
Circular Saw – to cut 48" Furniture shelves to size
(if needed)
Toggle bolts - if you are unable to hit a stud behind
the drywall
1. Before you begin, make sure that your wall is smooth and plumb – remove any obstructions such as old closet
organizers, cabinets or baseboards that may interfere with the installation.
2. By using your tape measure and level mark the locations of your base cabinets on the wall. Plan accordingly to
make sure drawers will open fully without obstruction!
3. Use your stud nder to locate the studs in your wall – mark either side of the stud and the center point, to show
where you need to hit with your installation screws. If necessary adjust the location of you cabinets slightly to
enable you to hit the required studs easily.
INSTALLATION STEPS FOR WALLS WITH WOOD STUDS
STEP 3ASTEP 2
Before you begin, please read this manual completely so
that you will have a good understanding of the sequence
of events.
Please follow all the safety instructions for tools
and procedures.
Note: Attachment to any
other surface material such
as metal studs, concrete
block, brick, stucco or
poured concrete require
special fasteners. Consult
with your local Home Depot
store or installation specialist
for recommended fasteners.
Got questions?
Customer Service:
1-866-373-9131
Monday - Saturday
9:00AM - 6:00PM EST
Email us at:
[e-mail]
Closet Cabinet
Installation Guide
TOOLS & MATERIALS REQUIRED