Manualshelf

Installation Guide

ManualsBrandsHome Decorators Collection ManualsCloset Storage & OrganizationAssembled Reach-In 15 in. D x 120 in. W x 84 in. H Calabria in a Twilight Melamine 11-Shelves Closet System
1234
24 in.
Base Cabinet
installation
4. Before you start, make sure the cabinets are empty.
5. Measure the distance from the outer edge of the rst base cabinet to the center of the studs you wish to attach to.
6. Transfer these measurements to the horizontal installation rail, along the back of the base cabinet.
7. Drill pilot holes thru the horizontal installation rail with a 3/32" drill bit. NOTE: If you can only hit one stud, use a drywall toggle bolt to
create a second attachment point (consult your local Home Depot store for the correct toggle for your wall construction).
**BASE CABINETS MUST HAVE TWO ATTACHMENT POINTS!
8. Attach base cabinet thru the drywall and into the studs using
#
10 x 3" pan head screws. Check that it’s level and shim if necessary.
(DO NOT FULLY TIGHTEN! Double check for shim and level and adjust if needed).
9. Using a 3/32” bit, drill (3) attachment pilot holes in the top of the Base Cabinet if you are placing a Wall Cabinet on top. Drill one hole on
the left and right side, near the front edge. Drill one hole, centered near the back, .
STEP 6STEP 5
STEP 7
STEP 8A STEP 8B STEP 9
B