Instructions / Assembly

WARNING:
CAUTION:
CAUTION:
CAUTION:
Operation (continued)
LIGHTING
1. Make sure all labels, packaging and protective films have been removed from the outdoor fire table.
2. Remove cover and burner lid (if applicable) before operating fire table. Check for obstructions of airflow to the burner.
Spiders, insects and webs can clog the burner/venturi tube. A clogged burner tube can lead to a fire.
3. Control knob must be in the “OFF” position.
4. To ensure proper function, the screen on the pilot housing should not be covered by glass beads.
5. Connect LP gas tank per steps 1 and 2 in the "Operation" section.
6. Turn LP gas tank valve to “OPEN”.
7. Push and hold the flame ignitor to create sparks within the electrode; and continue to hold.
8. Push in the control knob and turn to the “ON” position. Keep holding down the control knob to allow gas to flow for 20 seconds.
9. After 20 seconds, release and turn control knob counterclockwise to adjust flame to desired height.
10. If ignition does not occur in 20 seconds turn burner control knob to “OFF”, wait five minutes, fan with a newspaper or
magazine, and repeat lighting procedure.
18
CAUTION: Failure to follow these instructions
could cause a fire or an explosion which can cause
death, serious bodily injury or damage to property.
9.84 in-11.81in
25-30cm