Specification

30
Base Cabinets with No Doors
- Two full-depth adjustable shelves
- CUSTOM DEPTH: 9" to 23" deep
24" Deep Single Full Height No Door
B09ND
B12ND
B15ND
B18ND
B21ND
CUSTOM
DEPTH
- Two full-depth adjustable shelves
- CUSTOM DEPTH: 9" to 23" deep
24" Deep Double Full Height No Door
B24ND
B27ND
B30ND
B33ND
B36ND
CUSTOM
DEPTH
BASE CABINET CODING
B 30
Cabinet
Code
Cabinet
Width
· Standard Base Cabinets are 24" deep and 34½" high
· Matching interiors are standard in base cabinets with
no doors
· Standard cabinet exterior sides are color matched to
face frame
· Base cabinets are shipped with an unnished toekick.
Finished toekicks (MTK8) must be ordered separately
and eld installed.
· Shelf adjustment holes on the interior sides and
back of cabinets will be visible
Customize the depth of B24ND down to 12” you can use
it on the end of a cabinet run for an interesting transition
in the kitchen. This option is shown with a MWEP30 on
the exposed side of the ND (no door) cabinet to mimic a
nished door.
Use only one adjustable shelf in a B24ND or wider in your
laundry room to allow space to store laundry baskets.
Using ND Base Cabinets
Using ND Base Cabinets
If placing next to a wall - Must use BP1.5 or BP3 between wall
and pull out.
Base Filler Pull outs
21"
9", 12", 15", 18", 21"
34½"
24"
21"
24", 27", 30", 33", 36"
34½"
24"
Base Cabinets Design Tips
Make sure to give landing space on each side of a cooking
appliance when placing in design.
When placing a blind base cabinet, cabinet with drawer
or trash pull out, make sure to allow enough clearance so
drawer/pull out will open fully.
Make sure to leave enough space to allow drawer to open if
placing around corner from range or appliance.
Be sure to leave enough clearance for doors to open at
least 90 degrees. This will allow the roll out trays to be
operated correctly.
For sufcient dishwasher door clearance and loading/
unloading space, a 15" wide base cabinet is recommended
for use between a corner sink base and dishwasher.
Clearance for Roll Out TraysDesigning Around a Range
Blind Cabinets with Drawers Using a Sink Front Angle
31
Depending on the cut out dimensions the use of a ller (FS30), to
ll the gap between the bottom of the microwave and the drawer.
Consult the manufacturer specications for proper support and
possible use of a trim kit*.
*Trim kit and microwave will be purchased independently from
supplier of your choice.
This assembly requires a drawer base, either 24" or 30" wide -
depending on the size of the built in microwave you
purchase separately.
Assembly requires the onsite removal of the top two drawers from
the cabinet. Consult the manufacturer specications for cut out
dimensions, as additional modication may be required.
Built-in Microwave Base Modification