Installation Guide

Operation
 Turn on power at the circuit breaker or fuse box.
 Turn the light switch on to activate the fixture.
Care and Cleaning
EXTERIOR MAINTENANCE
 Use a dry or slightly dampened clean cloth
and wipe the surface of the fixture.
INTERIOR MAINTENANCE
 Disconnect power to the fixture by turning
off the circuit breaker or by removing the
fuse at the fuse box.
 Use a dry or slightly dampened clean cloth
to wipe the interior surface of the fixture.
Troubleshooting
7
NOTE: Do not use any cleaners with chemicals,
solvents, or harsh abrasives. Use only a dry soft
cloth to dust or wipe carefully.
Problem
Solution
The
light will not turn on.

Make sure the power supply is on.

Test or replace the switch.

Check the wiring.

Replace the driver.
The
fuse
blows or circuit breaker trips when light
is turned on.

Check the wire connections.
NOTICE: This device has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instruction
manual, may cause harmful interference to radio communications. However, there is no guarantee
that interference can be determined by turning the equipment off and on. The user is encouraged to
try to correct the interface by one or more of the following measures:
 Reorient or relocate the receiving antenna.
 Increase the separation between the device and receiver.
 Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
 Consult the dealer or an experienced radio/TV technician for help.
WARNING: Changes or modifications to this
unit not expressly approved by the party
responsible for compliance could void the user's
authority to operate the equipment.
FCC Notice