Use and Care Manual

PREPARE
1. The success and longevity of tile
installation relies on a solid base. Unless
you are dealing with new construction,
this usually means removing the original
material before you install your
new tile.
2. Ceramic and porcelain tile should be
installed on a clean, level and rigid
If your or have uneven areas,
repair and add support where needed.
Follow up with a cement board or
cement underlayment. Both are resilient
to moisture and impervious to liquids.
3. Choose your installation pattern. There
are an endless number of options, and
the pattern should
the overall tone
Installing porcelain tile is a process; proper preparation of the base is an absolute necessity for a success -
ful installation. Don’t let this dissuade you from a DIY porcelain tile installation! Below are instructions on
how to complete your project successfully.
and look you are trying to achieve.
4. Map out your installation. Measure to
the center of a room on two opposite
walls and use these points to snap a chalk
line across the room. Do the same on the
other walls to create perpendicular line,
and check to make sure they are square.
5. Dry your tile starting from center point,
leaving enough spacing for grout joints.
The goal is to work with as many full tiles
as possible.
Page 1 of 2Porcelain Installation Guide
PORCELAIN INSTALLATION GUIDE