Measurement Guide

10
FCC STATEMENT
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including
interference that may cause undesired operation.
Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate
the equipment.
NOTE: This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
□ Reorient or relocate the receiving antenna.
□ Increase the separation between the equipment and receiver.
□ Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
□ Consult the dealer or an experienced radio/TV technician for help.
RF WARNING STATEMENT:
The device has been evaluated to meet general RF exposure
requirement. The device can be used in portable exposure condition
without restriction.
IC NOTICE TO CANADIAN USERS
This device complies with Industry Canada license-exempt RSS
standard(s). Operation is subject to the following two conditions: (1)
This device may not cause interference, and (2) This device must
accept any interference, including interference that may cause
undesired operation of the device. This device complies with RSS247
of Industry Canada. Operation is subject to the condition that this
device does not cause harmful interference. This Class B digital
apparatus complies with Canadian ICES003 (Cet appareil numérique
de la Classe B conforme à la norme NMB-003 du Canada).
This equipment complies with IC radiation exposure limits set forth
for an uncontrolled environment. This equipment should be installed
and operated with minimum distance of 20 cm between the radiator
and your body. This transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter.
FCC RESPONSIBLE PARTY:
ONE WORLD TECHNOLOGIES, INC.
P.O. BOX 1288, ANDERSON, SC 29622
PHONE [phone]