Installation Guide

Limited Lifetime Warranty
The product has been manufactured by WoodCrafters Home Products, LLC and is warranted under normal use and service, to be free from defects in material
and workmanship for the life of the product from the date purchased. During this warranty period, WoodCrafters Home Products, LLC will repair or replace at
WoodCrafters Home Products, LLC sole option, free of charge, any defective part or parts returned with shipping charges prepaid to the distribution center listed
below. Please include the original receipt with date of purchase and the nature of the problem. Merchandise not returned prepaid will be refused. Our warranty
does not cover damage or failure caused by abuse, misuse, abnormal usage, faulty installation, improper maintenance or any repair other than those by
WoodCrafters Home Products, LLC . There are no obligations or liabilities on the part of WoodCrafters Home Products, LLC for consequential damage arising
out of or in connection with the use or performance of the product or any indirect damages included, but not limited to labor charges for installation or removal.
This warranty gives you specific legal rights, and you may also have other rights that may vary from state to state. Further information regarding this warranty may
be obtained without charge by contacting WoodCrafters Home Products, LLC Customer Service. If any Parts are missing or damaged, please call WoodCrafters
Home Products, LLC Customer Service at [phone], between 8:00 AM and 5:00 PM C.S.T.
WoodCrafters Home Products, LLC
2700 Camino de Verdad, Weslaco, TX 78596-1266
Revised July 2009
Installation
Instructions
Vanity Top
Care & Maintenance:
Customer Service 1-800-235-7747
SILICONE
How To Attach Vanity Top to Vanity
How To Attach Sidesplash/Backsplash
Your vanity top will remain in its original state if you maintain and clean it properly. Clean the
surface with a glass cleaner or other household cleansers that do not contain chlorine. Avoid
using abrasive cleaners as they will damage the surface. Should the top become stained or
scratched use a 600-grit sand paper and water.
SILICONE
glossy finish
1. Make sure the base of the vanity is leveled by laying a level across the top.
2. Set the vanity top on top of the vanity base, checking the location of the p-trap
and drain.
3. Remove the top and install the faucet per manufacturer’s installation instructions.
4. Hand tighten the pop-up drain with a wrench. Be careful not to over-tighten the pop-up
drain. Over tightening may cause cracks on the marble top.
5. Apply a thin bead of silicone compound around the vanity base and set the vanity top
carefully in place. Remove any excess silicone compound with a wet rag.
6. Attach water lines to faucet and connect the p-trap and drain.
1. Apply a thin bead of silicone on the back of the
sidesplash/backsplash. Carefully place and secure it to the
wall. Remove any excess compound.
2. Once secured, seal bottom portion of the
sidesplash/backsplash by applying a thin bead of silicone
on it. Let rest until dry.