Instructions / Assembly

Step 2
Step 1
Install the flooring planks including the underlayment by
leaving a 1" inch (25mm) gap for the installation
of the SlimTrim
Measure the door frame to determine width. Cut the
Versatrack to the appropriate size of the door opening,
leave a 1/2” gap on each side. Lay the Versatrack in the
position to be installed, and mark each of the holes with a
marker/pencil on the concrete floor. Make sure that the
track does not shift while marking each hole.
Flooring
Use Slimtrack for 1/8-1/4” (3 - 6.35 mm) floors.
1/8-1/4” (3-6.35 mm) Floors
Step 5
Gently press the molding into the track starting from one
end to the other just like you would close a Zip-Lock bag.
!!! Do not try to push the entire molding in all at once
by just pressing it in from top !!!
Slim Trim as a T-Molding CONCRETE Install
Installationadvice.com Solutions & Tools for problems that may arise
13
1/2”
1/2”
Measurement
12
3
45
6
7
89
1
0
11
12
13
1
4
15
17
1
8
19 20 2 1 2
223
2
4
25
26
2
7
28 29
30 31
1
23
45
6
16
789
10
11
1
2
3
4
56
7
2
F
1
F
General Disclaimer: Never drill into a slab that has radiant heating installed. Be aware of potential gas, electrical, water or low
voltage lines present in the slab before starting your project. If unsure about these circumstances, we strongly recommend to
use a glue down installation instead (See Page 4). The glue down option would require a high quality construction adhesive.
Step 3
Lay the track aside, and drill into the concrete floor by
means of a 1/4" masonry drill bit. Make sure the drill does
not 'dance' off the mark when starting to drill, as it will
otherwise bend the track when affixing to the floor. Drill
only as deep as your selection of dowel/screw combo
requires. Never drill deeper then 1-1/2" into the concrete!
Step 4 - Use your preferred method of screw dowel combo:
A - Screw + 0.375 x1.25” Wooden Dowel Pin: With
#6 x 1" screws, this option will give you a little bit more flexibility
in case the drill holes are not 100% in line with the trackholes.
Make sure you drive the wooden dowel flush with the concrete,
if it sits a bit high, scrape it flush with a chisel!
B - Screw + Plastic All-Purpose Anchor:
Start all screws
in each hole before you tighten one all the way down. This will
ensure that all holes line up properly with the track.
1”
Concrete
Concrete
Slim Track
DOWEL/SCREWABANCHOR/SCREW
+
+
Concrete
Slim
Track
Slim
Track
Wooden
Dowel Pin
Plastic
All-Purpose
Anchor
1/2”
Mark Holes
Here
12 3 4
Shim