Instructions / Assembly

*If the flooring manufacturer suggests/permits the use
of underlayments, you may need to shim the track to
accommodate the increase in overall thickness
9
3/8“
Installationadvice.com Solutions & Tools for problems that may arise
Step 3
Step 2
Step 1
Install the flooring plank*. Then place the SlimTrack 3/8”
from the floor and screw it to the sub-floor using
#6 screws.
Line the SlimTrim molding up with the SlimTrack and fit
one end into the molding. Using a rubber mallet, tap the
molding until it engages with the track.
Use your hand to
guide the molding into the track as you work your way down,
tapping it in, similar to how you would close a zip-loc bag.
Next, go up and down the molding several times, tapping the
Slim Trim all the way into the track. You can use a little more
force once you are sure it is properly engaged in the track.
Sub Floor
SlimTrack
SlimTrim as a REDUCER
Use SlimTrack (Metal Track) for up to 6.35 mm floors.
Up to 1/4” (6.35 mm) Floors
This end of the SlimTrim MUST be placed
on the lower of the two surfaces.
Rubber
Mallet
SlimTrim
SlimTrack
IMPORTANT: Rock SlimTrim back & forth to make sure
it is sitting inside the track BEFORE hammering in!
If SlimTrim wiggles back and forth, it is
NOT set in the track properly and will
be damaged when hammered in!
3
Use SlimTrack & Versatrack Shim for 6.35-9.5 mm floors.
Use the same molding & track, just add Versatrack Shim.
Sub Floor
3/8“
Step 3
Step 2
Step 1
Install the flooring plank*. Then place the SlimTrack & Shim
3/8”from the floor and screw it to the sub-floor using
#6 screws.
Line the SlimTrim molding up with the SlimTrack and fit
one end into the molding. Using a rubber mallet, tap the
molding until it engages with the track.
Use your hand to
guide the molding into the track as you work your way down,
tapping it in, similar to how you would close a zip-loc bag.
Next, go up and down the molding several times, tapping the
Slim Trim all the way into the track. You can use a little more
force once you are sure it is properly engaged in the track.
For 6.35 - 9.5mm WPC/LVT Floors
This end of the SlimTrim MUST be placed
on the lower of the two surfaces.
Rubber
Mallet
SlimTrim
SlimTrack
IMPORTANT: Rock SlimTrim back & forth to make sure
it is sitting inside the track BEFORE hammering in!
If SlimTrim wiggles back and forth, it is
NOT set in the track properly and will
be damaged when hammered in!
SlimTrack