Instructions / Assembly

Installationadvice.com Solutions & Tools for problems that may arise
Step 3
Step 2
Step 1
Install the flooring planks by leaving a 1" inch (25mm) gap for
the installation of the SlimTrim. Center the SlimTrack and the
2 Shims between the two laminate floors and screw them to
the sub floor by using #6 screws.
Line the SlimTrim molding up with the SlimTrack and fit
one end into the molding. Using a rubber mallet, tap the
molding until it engages with the track.
Use your hand to
guide the molding into the track as you work your way down,
tapping it in, similar to how you would close a zip-loc bag.
Next, go up and down the molding several times, tapping the
Slim Trim all the way into the track. You can use a little more
force once you are sure it is properly engaged in the track.
Sub Floor
SlimTrack
SlimTrim as a TRANSITION (T-MOLDING)
Use SlimTrack & 2 Versatrack Shims for 6.35-9.5 mm floors.
Use the same molding & track, just add Versatrack Shim.
For 6.35 - 9.5 mm WPC/LVT Floors
2 Shims
SlimTrack
2 Shims
1”
Rubber
Mallet
SlimTrim
SlimTrack
IMPORTANT: Rock SlimTrim back & forth to make sure
it is sitting inside the track BEFORE hammering in!
If SlimTrim wiggles back and forth, it is
NOT set in the track properly and will
be damaged when hammered in!
5