Instructions / Assembly

Installationadvice.com Solutions & Tools for problems that may arise
Step 3
Step 2
Step 1
SlimTrim as an END CAP
Use SlimTrack & Versatrack Shim for up to 6.35 mm floors.
Use the same molding & track, just add Versatrack Shim.
Up to 1/4” (0-6.35 mm) Floors
NOTE: Carpet Tap Down trim
must be even with the top
of the track.
1”
Sub Floor
Line the SlimTrim up with the track and fit one end into the
molding. Using a rubber mallet, tap the molding until it engages
with the track. Use your hand to guide the molding into the
track as you work your way down, tapping it in, similar to
how you would close a zip-loc bag.
Next, go up and down the molding several times, tapping the
SlimTrim all the way into the track. You can use a little more
force once you are sure it is properly engaged in the track.
Install the flooring plank and carpet (using a carpet tap down
trim) by leaving a 1" inch (25mm) gap for the installation of the
SlimTrim. Position the track 3/4” from where the of the Tap
Down trim meets the carpet and screw them to the sub floor
by using #6. The carpet tap down trim must be even with the
top of the track.
Carpet Tap
Down Trim
SlimTrim
SlimTrack
IMPORTANT: Rock SlimTrim back & forth to make sure
it is sitting inside the track BEFORE hammering in!
If SlimTrim wiggles back and forth, it is
NOT set in the track properly and will
be damaged when hammered in!
Rubber Mallet
This end MUST
be placed on
the lower
surface
6
1/8”
Use Shim
as Guide