Installation Guide

www.homelegend.com
DOC: HWH-V001
11 | Page
Step 1 – Establish a Starng Line
Step 2 – Spreading the Glue
a.) Spread the glue from the straight edge / chalk line out
towards the direcon of the starng wall. Spread only
enough glue to install what can be set within 45 minutes
(15 minutes of OPEN TIME and an addional 30 minutes
for actual installaon). Usually about two rows width
coverage. Different manufacturer may require different
open me and set me.
b.) You will repeat step 2a with each succeeding row.
Glue Down Installation
PLEASE NOTE:
ANY EXCESS GLUE WHICH GETS ONTO THE SURFACE OF THE FLOOR MUST BE REMOVED IMMEDIATELY WITH ADHESIVE
REMOVER
a) Select a straight starter wall.
b) Lay out the direcon of the floor. If possible, install the
flooring perpendicular to the joists.
c) Mark the starng line using a chalk line. This distance between
the wall and the line should equal the face width of 2 floor
planks plus 3/4” (create expansion gap by leaving ½” space
between wall and cung off the ¼” tongue from the long side
of the plank).
d) Securing a straight edge on the side away from the starng
wall is recommended to ensure straight alignment of the
starter rows
Step 3 – Install the Starter Rows (first two rows)
a.) Installaon begins from the straight edge / chalk line
out with tongue facing away from the wall.
b.) Allow expansion gap between the wall and the end
of the board.
c.) Use a 75-pound roller to roll the flooring
immediately aer 150 square feet.
d.) Remove straight edge and connue with the
installaon.
2a