Installation Guide

Doc. ID: 186 Rev: 2 Effective: 1/7/2015 Page | 5
Note:
Expansion gaps around pipes.
• Measure the diameter of the pipes and mark the position on the floorboard. There should be a 5/16 to 3/8 inch
expansion gaps between the floor panel and the pipe or other vertical structures.
• Cut out the holes.
• Saw the board widthwise through the holes.
Door frames may have to be undercut.
• Use a floor panel as a guide as to how much to saw.
• Put the floor panel faced down as a guide.
• Saw off the bottom of the door frame to allow the floor panel to slide under it.
Technical Support
For installation information and technical questions not covered in this installation guide, please contact our Technical Support
Representative by calling the toll free number below.
Toll Free Number: 877-630-1800