Instructions / Assembly

Customer Service Hotline [phone]-PURE
Page 12
Home Master® Reverse Osmosis System—Owners Manual
USING QUICK CONNECT FITTINGS
Customer Service Hotline [phone]-PURE
Page 5
Home Master® Reverse Osmosis System—Owners Manual
3. Install drain saddle clamp and drain line – Identify a
vertical section of drainpipe with enough space to mount the
drain saddle clamp. NOTE: A horizontal section of pipe is less
desirable but can be used provided the drain saddle opening
flows downward into the pipe, like a manhole drops down into
the sewer. DO NOT mount the drain saddle between the P-trap
and the wall. The drain pipe material can be either metal or
plastic. Locate drain hole template supplied with drain saddle
clamp, and peel off its backing. Place the template on the
previously identified location of drainpipe for the drain saddle
clamp. Place ¼” drill bit inside template hole, and drill a hole
into the drainpipe. Drill through one side only. DO NOT drill a
hole clean through both sides of the drainpipe. This will result
in a leak, and require replacement of that piece of drainpipe. Mount the drain saddle clamp on
top of the template with the holes aligned. You may use a screwdriver to align the holes. Fit
drain saddle clamp back-plate and screws. Alternate tightening screws on each side of the
drain saddle clamp to ensure an even, snug fit.
3a. Mounting Permeate Pump
(optional) - Mount permeate pump side
by side with the Home Master® RO using
supplied mounting clip and screws.
IMPORTANT: permeate pump must
be mounted with indicator arrow
pointing up. Indicator arrow is the
large, center arrow. See mounting
orientation diagram below.
3b. Install refrigerator kit (optional)
– Installation may vary according to
make, model, and age of your
refrigerator. Make sure refrigerator
icemaker and water center are turned
OFF. Clean area below and around
refrigerator thoroughly. Use care when
rolling out refrigerator. Flooring may become scratched, gouged or damaged from moving
refrigerator. Consult your local licensed contractor or plumber for trimmed-in refrigerators, or
refrigerators without rollers. Roll out refrigerator. Unplug refrigerator electric plug. Locate
water line in for refrigerator. (Yours may already be connected to a water line from wall. If so
use local angle-stop to shut off water. Disconnect female fitting.) Plan the route for the water
line from the Home Master® RO. Drill ¼” holes through the lower cabinetry, high along the
back wall just below the drawers. Make sure cabinet contents are removed, prior to drilling,
and ¼” tubing does not come into contact with drawers, doors, or sharp objects. Smooth the