Installation Guide

Assembly Instructions
2
STEP 1
Attach Legs (B) to Side Frames (C) with
Flat Washers, Spring Washers, Nuts and
Nut Caps. (See Figure 1 and Figure 2)
Place Top (A) upside down on a soft cloth.
STEP 2
Insert Bolts into the pre-drilled holes of Top (A).
(See Figure 3)
Attach unit to Top (A) with
Flat Washers,
Spring Washers,
Nuts and Nut Caps.
Turn the unit over to its’ upright position.
STEP 3
Cover the umbrella hole with Cover.
To level the unit, adjust the adjustable
levelers on the bottom of legs.
(See Figure 4)
C
C
A
C
C
B
B
B
B
Figure 1 Figure 2
Figure 3
Figure 4
Flat Washer
Flat Washer
Spring Washer
Spring Washer
Nut
Nut
Nut Cap
Nut Cap
Bolt
Cover
/2
IMPORTANT
* Please keep Key Wrench in a safe place as you may need to tighten up the Nuts in the future.
* Use a soft cloth between these parts and the f oor.
* Do not use power tools to assembly and do not overtighten the bolts and nuts.
* Do not tighten up all the bolts and nuts until each part is properly assembled.
* After assembly item must be level to work properly. Use the included adjustable levelers to level.