Operation Manual

INSTRUCTIONS FOR USE:

For use in the office or home

NOTE: complete steps 1 to 3 before switching the appliance on at the mains.

1. Attach the Massage cushion to almost any chair using the integrated strap located at the

back of the seat. Ensure it is held firmly in place by adjusting the strap as necessary.

2. Connect the power supply lead from the adaptor with the corresponding lead in the side of

the seat.

3. Plug the adaptor into a 230V mains outlet and switch on.

4. Once seated, use the remote control to operate the appliance. Press the ‘Power’ button

and select the desired massage zone and heat button (if desired) to start the massage.

Refer to the illustration of the remote control for further explanation on the different

programmes available.

5. Press the ‘Power’ button to stop the massage.

For use in the car

1. Attach the Massage seat using the integrated strap located at the back of the seat. Ensure it

is held firmly in place by adjusting the strap as necessary.

2. Connect the power supply lead from the 12V auto adaptor with the corresponding lead in the

side of the seat.

3. Plug the adaptor into a 12V power supply in the car.

4. Refer to steps 4 & 5 in the section above for further instructions for use.

NOTE:

• The ‘Heat’ function is pressure activated and will not function unless pressure is applied to the

base of the seat. For safety purposes, heat will only function when massage is activated.

• Only gentle force should be exerted against the seat in order to eliminate risk of injury.

• There is a 15 minute auto shut-off on this appliance for your safety. This feature should not be

considered as a substitute for ‘OFF’. Always remember to switch the appliance off when not

in use.

• Take care to position the product where it will not damage wooden or upholstered surfaces.

MAINTENANCE:

Cleaning

Unplug the appliance and allow to cool before cleaning. Clean only with a soft, slightly

damp sponge.

• Never allow water or any other liquids to come into contact with the appliance.

• Do not immerse in any liquid to clean.

• Never use abrasive cleaners, brushes, glass / furniture polish, paint thinner etc to clean.

Storage

Place the appliance in its box or in a safe, dry, cool place. Avoid contact with sharp edges or

pointed objects which might cut or puncture the fabric surface. To avoid breakage, DO NOT

wrap the power cord around the appliance. DO NOT hang the unit by the cord.

HM7654 BKP-300-2EU_IB.qxd:Layout 1 23/1/07 18:09 Page 5