Instruction Manual

ManualsBrandsHoMedics ManualsHealth CareFoot Massager

INSTRUCTIONS FOR USE

To reduce the risk of electric shock, this unit is equipped with a polarized plug (one blade

wider than the other). This plug will fit in a polarized outlet only one way. If the plug

does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified

electrician to install the proper outlet. Do not change the plug in any way.

1. Plug into a 120-volt outlet.

2. It is highly recommended that you wear socks while using this foot massager. Do not use

the unit with shoes.

3. Place massager on the floor in front of your chair or seat and place feet in massager.

4. For your convenience, a wireless remote control is included. You can use the buttons on the

remote control or the corresponding buttons on the massager with the touch of your toe

to activate and customize your massage. The buttons on the massager will illuminate to

confirm your selection.

5. To activate massage, press the power

button. The power button on the massager

will illuminate white to confirm your selection. The unit will start with both air and knead

at low intensity.

MODE BUTTON

1. Pressing the “MODE”

button starts the unit with both air and knead in low intensity.

Both sides of the “MODE”

button will be illuminated (Fig. 2).

2. Pressing the “MODE”

button again will change the unit to air only. The right side of the

“MODE”

button will illuminate green.

3. Pressing the “MODE”

button a second time will change the unit to knead only. The left

side of the “MODE”

button will illuminate blue.

4. Pressing the “MODE”

button once more will return the unit to air and knead. “AIR”

intensity, “MODE,” and “KNEAD” intensity buttons will all be illuminated.

NOTE: You can adjust the intensity of air or kneading by pressing the “AIR”/“KNEAD”

button.

AIR INTENSITY BUTTON

1. Pressing the “AIR” intensity

button will allow you to adjust the intensity of the air

pressure, or how firmly it squeezes your feet. (Fig. 3).

2. When first turned on, air intensity will begin in the lowest setting, with the

button

illuminated dull green.

3. Pressing the

button again will change the foot pressure to medium, indicated by a brighter

green.

4. Pressing the

button a third time will change the pressure to high, indicated by the

brightest green.

5. Pressing the

button once more will return the pressure to its lowest setting.

Fig. 1

Fig. 2

Fig. 3