™ M ake A omen tN eT as Register ow Pl e for Arms & Legs Your Product At: www.homedics.com/register Your valuable input regarding this product will help us create the products you will want in the future. For more information, please visit www.rapidreliefpad.com HW-P100 Ver.
Other Accessories Included: CR 2032 Li-Mn 3V •1 CR2032 Lithium Battery •Carry Case •Gel Pads Read before you use This device should never be used to relieve undiagnosed pain. Before treating any symptoms of pain, you should consult your doctor. Warnings • Never use this device near the heart, around the mouth, or on diseased skin. • Do not use this device in places with high humidity such as the bathroom. • May need to use under the supervision of a physical therapist. • For external use only.
• Do not use the device over twice a day on the same place of your arms and/or legs. • Caution should be used with the following conditions: - Have had a recent surgical procedure where muscle contraction may disrupt the healing process. - Over areas of the skin that lack normal sensation. • Gel pad placement and stimulation settings should be based on the guidance of the Instruction Manual. • The long-term effects of electrical stimulation are currently unknown but is rapidly advancing.
• Do not apply device for undiagnosed pain syndromes until etiology is established. • Have seizure disorder, unless consulting with a physician, example: epilepsy. • Are pregnant or menstruating. • Have cancer. • Had arm or leg operations before, and the pain is caused from past surgery or accident. • Are suffering from a metabolic arthritis. • Device should not be applied over swollen, infected, inflamed areas, or skin eruptions, ex. phlebitis, thrombophlebitis, varicose vein, etc.
INDICATIONS FOR USE Arm & Leg Pain Place this device where you appear to have pain. For optimum result, move device to the other spot indicated on the image on the left, after finishing 20 minute cycle. BATTERY AND GEL PAD ASSEMBLY 1. Use a coin or small device to turn the battery door to the OPEN position. 5. Remove blue film from the gel pads. 2. Flip open battery cover with a pin. 3. Insert battery provided “+” side up (CR2032 4. Close and lock battery cover. 6.
HOW TO OPERATE 1. Press and hold + button for 3 seconds to power the unit ON and listen for the beep. Note: The unit will not operate if it is not in contact with your skin. 2. Press + button again to activate device. Continue to press the + button until you feel the sensation of the impulses. 3. Use +/- button to adjust intensity level, note there are 15 levels. 4. The device automatically powers off after 20 minutes, or press and hold - button for 3 seconds to power OFF.
MAINTENANCE Storage of the device: (1) Keep the device away from children. (2) Remove the battery if the unit will not be used for more than 10 days. (3) Place the device into the protective carry case to protect the adhesive gel pads and device. (4) Do not store the unit under high temperature, high humidity, direct sunlight, exposed environment or where there is a lot of dust or corrosive gas.
CAUTION • If the unit is not functioning properly or causes discomfort, stop using it immediately. • Press and hold the - button for 3 seconds to turn the device OFF before removing the device from the skin. Note: If removed from skin before turning unit off, you may receive a small zap on your fingers that may be uncomfortable. • If the gel pads are dirty, dry or sticking to hair, it might cause skin discomfort. Please replace it immediately.
TROUBLESHOOTING SYMPTOMS Unit fails to turn on. Gel pads are no longer sticking to the body. CORRECTION Press and hold the + button again for 3 seconds. Check if the battery is properly placed, the “+” side facing up and in connection with the contact points, try again. Battery may no longer be good. Replace the battery and try again. Clean the gel pad with a drop of water on your finger. Replace gel pad.
Beep Signal Description Chart Power Mode Operation Types of Beep Signal Unit is turned off hold the + button 3 seconds Single long beep The unit has turned on. Short press of the + or - buttons The intensity adjustment feature is disable because the gel pad is Two short beeps not in full contact with the skin. Reapply the gel pad and try again.
Beep Signal Description Chart cont’d Power Mode In Use Operation Types of Beep Signal Signal Description Short press of the + button Single short beep The adjustable intensity feature has increased 1 level. Short press of the - button Single short beep The adjustable intensity feature has decreased 1 level. The adjustable intensity feature Multiple presses of the Two short beeps has reached 15, the maximum + button level.
Product Specifications Power CR2032 Lithium battery 3V Pulse Rate 2-40Hz (Fixed) Pulse Width 200µs (Fixed) Output Voltage Treatment Time Pulse Strength Max.68.8 Vpp, based on 500 Ω load ± 10% 20 minutes; auto-off 0 ~ 15 stages adjustable Operation Environment -10 ~ 40°C, 30 ~ 85% Relative Humidity Storage Environment -10 ~ 50°C, 10 ~ 95% Relative Humidity Transportation Environment -10 ~ 50°C, 35 ~ 85% Relative Humidity Size 4.5˝ x 2.8˝ x .
LIMITED ONE YEAR WARRANTY For service or repair, do not return this unit to the retailer. Contact HoMedics Consumer Relations at: Email: cservice@homedics.
™ n momento eu ah es o m Registre ra Tó Para brazos y piernas su producto en: www.homedics.com/register Su valioso aporte sobre este producto nos ayudará a crear los productos que desee en el futuro. Para obtener más información, por favor visite www.rapidreliefpad.com HW-P100 Ver.
Otros accesorios que se incluyen: CR 2032 Li-Mn 3V •batería de litio CR2032 •Estuche de transporte •Almohadillas de gel Lea antes de usar Este dispositivo nunca debe usarse para aliviar un dolor no diagnosticado. Antes de tratar cualquier síntoma de dolor, debe consultar a su médico. Advertencias • Nunca use este dispositivo cerca del corazón, alrededor de la boca o sobre la piel enferma. • No use este dispositivo en lugares con mucha humedad, como el baño.
• Se debe tener cuidado en las siguientes condiciones: - Si se ha sometido recientemente a un procedimiento quirúrgico donde la contracción muscular puede afectar el proceso de cicatrización. - En áreas de la piel que no tienen sensibilidad normal. • La colocación de las almohadillas de gel y las configuraciones de estimulación deben basarse en la guía del Manual de instrucciones. • Actualmente se desconocen los efectos a largo plazo de la estimulación eléctrica, pero están avanzando rápidamente.
No use el dispositivo en las siguientes circunstancias: • Si tiene un marcapasos, un implante metálico, una bomba de insulina o cualquier otro implante en el cuerpo. • En el caso de pacientes con enfermedad de miocardio o arritmia conocida, el dispositivo debe usarse únicamente si se consulta a un médico especializado para que evalúe la situación. • No aplique ningún electrodo en una ubicación que cause la circulación de corriente por la cabeza. • No use el dispositivo sobre los párpados.
Es importante el uso correcto de este dispositivo para obtener alivio temporal del dolor. Dedique los siguientes minutos a leer este manual con atención y aprender el funcionamiento correcto de este equipo fácil de usar. Este dispositivo Rapid Relief está indicado para el alivio temporal del dolor asociado con músculos doloridos en los brazos y/o las piernas debido a una distensión provocada por actividad física o por actividades normales del trabajo o del hogar.
INDICACIONES DE USO Dolor en los brazos y las piernas Coloque este dispositivo donde parece tener dolor. Para un óptimo resultado, después de finalizar un ciclo de 20 minutos, mueva el dispositivo hacia el otro lugar que se indica en la imagen ubicada a la izquierda. COLOCACIÓN DE LA BATERÍA Y LAS ALMOHADILLAS DE GEL 1. Use una moneda o un dispositivo 2. Abra la tapa del 3. Introduzca la batería 4.
CÓMO USAR EL DISPOSITIVO 1. Presione el botón + y manténgalo presionado durante 3 segundos para encender la unidad y escuchar una señal sonora. Nota: la unidad no funcionará si no entra en contacto con la piel. 2. Presione el botón + nuevamente para activar el dispositivo. Continúe presionando el botón + hasta que perciba la sensación de los impulsos. 3. Use el botón +/- para ajustar el nivel de intensidad; tenga en cuenta que hay 15 niveles. 4.
MANTENIMIENTO Almacenamiento del dispositivo: (1) Mantenga el dispositivo alejado de los niños. (2) Retire la batería si la unidad no se va a usar durante más de 10 días. (3) Coloque el dispositivo en el estuche de transporte protector para proteger las almohadillas de gel adhesivas y el dispositivo. (4) No guarde la unidad en un ambiente con temperaturas altas, humedad elevada, bajo la luz solar directa, en un ambiente expuesto o en un lugar donde haya gran cantidad de polvo o gas corrosivo.
Reemplazo de las almohadillas de gel: (1) Para extraer la almohadilla de gel, enróllela cuidadosamente con los dedos de la mano con el gel hacia arriba hasta que la almohadilla se haya despegado por completo. Nota: no use las uñas ni herramientas ya que esto puede dañar la unidad. (2) Repita este paso en el otro lado. (3) Coloque una gota de agua sobre su dedo de la mano para limpiar el dispositivo y eliminar residuos. Deje que se seque.
DIAGNÓSTICO Y RESOLUCIÓN DE PROBLEMAS SÍNTOMAS SOLUCIÓN Vuelva a presionar el botón + y manténgalo presionado durante 3 segundos. Verifique que la batería esté colocada correctamente, con el La unidad no se lado “+” hacia arriba y en conexión con los puntos de conenciende. tacto. Intente nuevamente. Es posible que la batería no sirva más. Reemplace la batería e intente encender el dispositivo nuevamente.
Cuadro de descripción de señales sonoras Modo de encendido Funcionamiento La unidad está apagada Mantenga presionado el botón + durante 3 Un pitido largo segundos La unidad se ha encendido. Presione brevemente Dos pitidos el botón + o cortos La función de ajuste de intensidad está deshabilitada porque la almohadilla de gel no está en contacto completo con la piel. Vuelva a aplicar la almohadilla de gel e intente nuevamente.
Cuadro de descripción de señales sonoras Modo de encendido Funcionamiento Tipos de señal Descripción de la señal sonora Presione brevemente Un pitido corto el botón + La función de intensidad ajustable ha aumentado 1 nivel. Presione brevemente Un pitido corto el botón - La función de intensidad ajustable ha disminuido 1 nivel.
ESPECIFICACIONES DEL PRODUCTO Energía Batería de litio CR2032 de 3 voltios Pulso 2-40 Hz (fijo) Ancho del pulso 200 µs (fijo) 68.
GARANTÍA LIMITADA DE UN AÑO No devuelva esta unidad al distribuidor para obtener servicio o reparación. Comuníquese con Relaciones con el Consumidor de HoMedics en: Correo electrónico: cservice@homedics.com Teléfono: 1-800-466-3342 Horario comercial: 8:30 a. m. a 7 p. m.