Downloadable Instruction Book

7
MAINTENANCE
Storage of the device:
(1) Keep the device away from children.
(2) Remove the battery if the unit will not be used for more than 10 days.
(3) Place the device into the protective carry case to protect the adhesive gel pads
and device.
(4) Do not store the unit under high temperature, high humidity, direct sunlight,
exposed environment or where there is a lot of dust or corrosive gas.
Care for Device
(1) To avoid damage to the device:
- When removing the device from the carry case pull out gentle and slow.
- Do NOT twist the device.
- Do NOT pull on the device pads strongly, or pull outward from the device center.
- Do NOT push or pull on the device center, this can deform the device causing
operation issues.
- Do NOT disassemble any part of the device.
Care for gel pads:
(1) If the adhesive gel pads get dirty or less sticky you can prolong the life for
additional uses by cleaning it. With a drop of water on your finger, rub the water
over the surface of the gel and allow it to dry.
(2) Always store the gel pads in the protective case after use. Do not store it in other
areas, or adhere the gel to a surface other than your skin or the inside of the
protective case as this can damage the gel and reduce the life of it.
(3) Be sure the skin is clean before the gel pads are placed on the body.
(4) Always store in a cool, airy area away from direct sun light.
Replacing the gel pads:
(1) To remove the gel pad carefully roll the gel upwards with your fingers until the
entire pad has lifted off. Note: Do not use fingernails or tools as they can damage
the unit.
(2) Repeat on other side.
(3) Clean the device with a drop of water on your finger to remove left over residue.
Allow to dry.
(4) Place new pads onto the unit following steps 5-8 in the Battery and Gel Pad
Assembly section.