operation manual
37
Operation
You can manually start the teach-in mode for an-
other 3 minutes by pressing the system button (B)
shortly (see figure 4).
• Your device will automatically appear in the
Homematic IP app.
• To confirm, please enter the last four digits of the
device number (SGTIN) in your app or scan the
QR code. Therefore, please see the sticker sup-
plied or attached to the device.
• Please wait until teach-in is completed.
• If teaching-in was successful, the device LED (A)
lights up green. The device is now ready for use.
• If the device LED lights up red, please try again.
• Please select, in which application (e.g. light or
security) you would like to use the device.
• Allocate the device to a room and give the device
a name.
6 Operation
After teaching-in, you can control the switch circuit board
e.g. using a connected Homematic IP Remote Control or
the Homematic IP app and switch connected devices on
or o.
Simple operating functions are available also directly on
the device: