Installation Instructions

6 | P a g e
Rev 05/2015
USAGE
 Door system
MAKE SURE ALL THE WATER IS DRAINED FROM THE TUB BEFORE OPENING THE
DOOR!!!
 If your tub door has the locking system like figure 2, please follow the
instructions below to open and close it.
 Pull out the safety lock (shown in figure 1) before opening the door
 Hold the door handle and pull it towards hinge (figure 2)
 After entering the tub, with one hand, pull the handrail to insert the
locking bolt. Press in the safety lock
 If your tub had the locking system in figure 3, please follow the instruction
below to open and close it
 When entering the tub, hold the door handle and pull it away from the
door hinges
 After entering, with one hand push the door closed and with the other
hand push the door handle towards the hinge.
 Repeat the first step here to open the door after bath.
 If your tub has the locking system in figure 4, please follow the stops to
close and open it.
 Before entering the tub, hold door handle with the safety button pressed
down and push it towards the door hinge to open the door (figure 3)
 After entering the tub, with one hand pull the door closed and with other
hand pull the door handle, the locking bolt and its safety loc with
engage automatically.
 Repeat first step to open the door after bath.
Warning:
(1). Before closing the door, please make sure that the bold bar is completely
in the door. Otherwise the crossbar will hit and scrape the bathtub
(2). When using the walk-in tub, please make sure the door is closed properly
and the safety lock in engaged.
(3). The door handle is only for opening and closing the door. Do not sit or
rest any heavy objects on the door.
(4). Make sure the safety lock is engaged when the bathtub is full or being
filled with water. Please steer clear of contact with the door handle to
avoid accidentally opening the door. Otherwise the water will pour out.
 Thermostatic valve use guide
 Connect to the water supply, turn on the faucet knob (figure 5, 6, 7)
 Turning mixing knob for desirable temperature setting (note the red and
blue marks indicate hot and cold water on the mixer knob)
 Turn off the water filler when tub is filled
Note: the water level must be above the back jets
 When using handheld shower, turn on the handheld shower knob and
follow step 2 to adjust water temperature
Warning:
(1). Before filling with water, please set the temperature to its lowest setting to
avoid scalding.
(2). You can gradually adjust the temperature to set the desired warmth.